Antenna Calculators

Loading the antenna calculators…

How to Use the Antenna Calculators

Pick an antenna, enter a frequency, and get cut lengths with a drawing of the antenna and a printable cut sheet for the workbench. Lengths come out in feet and inches or metric.

  • Dipole and inverted V, with NVIS heights and a trim helper.
  • End-fed half-wave, including the harmonic bands one wire covers.
  • Quarter-wave and 5/8-wave verticals with radials, a J-pole and Slim Jim, and a full-wave loop.
  • Moxon rectangle from L.B. Cebik’s published equations, and a 2 to 7 element Yagi.
  • Random wire lengths to use and to avoid, coax loss with SWR, and a wavelength and stub calculator.

Why isn’t my antenna resonant at the calculated length?

The formulas are a starting point. Insulated wire, height, nearby trees and buildings, and the feedpoint hardware all make a wire act a little longer than it measures. Cut long, check the SWR dip with an analyzer, and trim a little at a time. If the dip is below the band, the wire is too long.

End-fed half-wave or random wire?

They look the same in a tree but work in opposite ways, with different transformers. An EFHW is cut to a half wave and needs no tuner on its harmonic bands. A random wire is cut to avoid half waves and always needs a tuner. EFHW vs Random Wire explains which to build.

Does it work offline?

Everything runs in your browser once the page loads. Print the cut sheet before you head out to the field.

×